APPLIED MOTION StepSERVO technology featuring space vector current control, NEMA 23 frame size, EtherNet/IP support for easy PLC and HMI communication, Q programming control mode for stand-alone operation, “Boost” torque of 25-50% higher than holding torque, RJ45 Ethernet port for programming and communications, Built-in 20,000 count/rev encoder for closed-loop control.
*** TARIFF SURCHARGE MAY APPLY ***
*** TARIFF SURCHARGE MAY APPLY ***
Part Number: SSM23IP-2EG
Supply Voltage: 12-70 VDC
Supply Voltage Type: DC
Current Draw from Power Supply: 3.2 A max
Control Modes: Step & Direction, Analog Torque / Velocity, Streaming Commands, Analog Positioning, Encoder Following
Q Programming, EtherNet/IP, Velocity Control, Modbus TCP Communication Ports: Ethernet, EtherNet/IP
Encoder Feedback: Yes
Encoder Resolution: 5,000 lines (20,000 counts quadrature)
Setup Method: Software setup
Digital Inputs: 3
Digital Outputs: 1
Analog Inputs: 1 single-ended
Circuit Protection: Short circuit, Over-voltage, Under-voltage, Over-temp
Status LEDs: 1 red, 1 green
Frame Size: NEMA 23
Holding Torque: 142 oz-in
Step Angle: 1.8 deg
Rotor Inertia: 3.68E-03 oz-in-sec2
Length: 3.64 inches
Weight: 30 oz
Ambient Temperature Range: 0 to 40 °C
Ambient Humidity: 90% max, non-condensing
Insulation Class: Class B (130 ºC)
Shaft Diameter: 6.35 mm (0.250 inch)
Maximum Radial Load: 11.2 lbs
Maximum Thrust Load: 1.8 lbs
Shaft Run Out: .002 inch
Radial Play: .0008 inch
End Play: .003 inch
Perpendicularity: .004 inch
Concentricity: .003 inch